I8 Wireless Scanner Quick Setup Guide

• System Settings
  • Restore Default Settings
  • Get Firmware Version
  • Volume Settings
  • Battery Information
  • Sleep Time
• Working Mode
  • Normal Mode
  • Storage Mode
• Wireless Mode
  • One-to-One Pairing
  • Receiver Keyboard Transmission Speed
  • High Speed
  • Medium Speed
  • Low Speed
• Wired Mode
  • Transmission Mode
  • Automatic Selection Of Wired/Wireless Transmission
  • USB Keyboard Speed
  • USB HID Multi-Key Send Set
• Bluetooth Mode
  • Bluetooth HID
  • Bluetooth SPP
  • Bluetooth BLE
  • Clear Pairing Information
  • IOS Popup/Hide Keyboard
  • Bluetooth Keyboard Transmission Speed
  • Modify Bluetooth Name
• Keyboard Settings
  • Case Settings
  • Keyboard Language
• Data Editing
  • Output Format
  • Prefix
  • Suffix
  • Hide Set
  • Quick Setup
  • Appendix
• Symbologies
  • Start Setup
  • Enable All Symbologies
  • Only Enable 1D Symbologies
  • Only Enable 2D Symbologies
  • Block Barcodes With URLs
  • End Setup
• Terminator
  • Start Setup
  • End Character Settings
  • End Setup
• Scan Mode
  • Start Setup
  • Key Trigger Mode
  • Auto Sensing Mode
  • Continuous Mode
  • End Setup
• FAQ
  • Question 1: The scan is successful, the buzzer sounds once, but no data is uploaded?
  • Question 2:The scanner scans successfully, beeps twice, and can upload data normally. What is going on?
  • Question 3:The scanner scans successfully, beeps three times, and fails to upload data. How can I solve this problem?
  • Question 4:The scanner beeps five times when a button is pressed. How can I solve this problem?
  • Question 5:Scan successful, uploaded data incorrect?

Note

Barcode scanners are factory programmed for the most common terminal and communications settings. If you need to change these settings, programming is accomplished by scanning the bar codes in this guide. An asterisk (*) next to an option indicates the default setting.